Citroen C5 & C6 2.7 & 3.0 HDi Rear Oil Seal
Citroen C5 & C6 2.7 & 3.0 HDi Rear Oil Seal Citroen C5 & C6 2.7 & 3.0 HDi Rear Oil Seal

Citroen C5 & C6 2.7 & 3.0 HDi Rear Oil Seal

Brand: Glaser
Model P77677-01
Availability: 5
Price: £50.40
Ex Tax: £42.00
Qty:     - OR -   Add to Wish List
Add to Compare

Citroen C5 & C6

Rear Oil Seal

Fits models C5, C6

Engine Codes 
 DT20C, DT17ED, UHZ (DT17BTED4)

PLEASE READ THIS FITMENT GUIDE BEFORE ASSEMBLY! CLICK HERE

* Important fitting information * 

1. Only remove PTFE oil seals from their protective packaging immediately before installation, to protect them from dust and other contamination. 

2. The sealing lip of PTFE oil seals is protected by a plastic sleeve, which can normally be used as an assembly aid. Therefore, the sleeve should remain in place until the seal has been installed. 
 
3. If the seal is to be installed without the sleeve, use the special tool provided by the manufacturer. 

4. Both the PTFE sealing lip and the shaft surface must be completely dry. Do not use any grease or oil. 
 
5. The shaft may not exhibit any sharp-edged chamfers – if necessary, have the edges removed by an engine expert.
 
6. The shaft surface must be in a perfect condition – also here, possible damage must be repaired by an expert. 
 
7. Position the assembly sleeve with the PTFE oil seal on the shaft. 
 
 8. Make sure that the sealing ring is aligned correctly – the sleeve must be located so that the seal can be pushed onto the shaft smoothly. 
 
 9. Push the sealing ring onto the shaft with an even motion. 
 
10. When replacing, the PTFE lip of the new seal should not run in the same position as the old one. 
 
11. You can now remove the assembly sleeve. 
 
12. Do not start the engine sooner than four hours after installation – this permits the new sealing lip to adapt perfectly to the shaft.


The most frequent cause for failure is damage to the PTFE sealing lip during assembly. If the seal is installed without the help of a sleeve or special tool and is shifted or even turned inside out, reliable sealing will hardly be possible. Similarly, the use of oil or grease – as with classical oil sealing rings – will result in total failure of the PTFE oil seal immediately after installation.
 

Free next day delivery - UK Mainland only

If you require any assistance or would like to ask any questions, please click below

Make Model Engine Years
Citroen C5 Diesel - 3.0 2992cc 2009 - 2019
Citroen C6 Diesel - 2.7 2720cc 2005 - 2019
Citroen C6 Diesel - 3.0 2993cc 2009 - 2019
Engine Information
Engine Codes DT20C, DT17ED, UHZ (DT17BTED4)
Engine Size 2720cc, 2992cc
Engine Type Diesel

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Copyright 2021 - Lymm Engine Components Ltd.
5 Birch Court, Grosvenor Grange, Warrington. WA1 4GD